Costar 9RV Manuel du propriétaire télécharger pdf (Page 7)

Installation

For best performance at high ambient temperatures, there must be free air

circulation over the cooling unit at the rear of the refrigerator.

Ensure that there is a free air space above the refrigerator and that the flue

(chimney) on top of the cabinet is not covered in any way. Do not place the

refrigerator in a space where air circulation is restricted. Follow “clearance”

instructions.

This free-standing refrigerator requires accessibility to the back for servicing the

gas equipment, which can be obtained by using a certified Flexible Metal

Connector to allow the refrigerator to be withdrawn without disrupting the gas

supply. “Where a flexible metal connector is used, it must comply with local

authorities and in Canada with the provisions of the current Standard CAN 1-

6.10, Metal Connectors for Gas Appliances”. However, if the Local Authorities

require a rigid gas supply connector, the refrigerator should be located with

sufficient space at the back for servicing or, if located against a wall a removable

panel of a minimum size of 16” x 20” should be provided in the wall to allow

access to the rear of the refrigerator. . If you purchased a CM (CO Monitor

model) you must follow instructions in Section 6 - 5.0 onward.

Heat Shield

The heat shield must be installed before operating the

appliance. This is a CSA requirement.

Un-wrap the heat shield (located inside the box along

with the appliance). Mount heat shield with the

screws (supplied) to right side of the fridge.

Chapter

Heat Shield

1 2 3 4 5 6 7 8 9 10 11 12 ... 49 50

Pas de commentaire

Costar 9RV Manuel du propriétaire Page 7